Right Rear Wheel Housing Liner

Right Rear Wheel Housing Liner

Removing






Perform the following:

- Remove the wheel.

- Loosen the wheel cover - 8 - near the bumper.

- Remove the bolts - 5 - and nut - 6 -.

- Remove the rear wheel housing liner - 1 - from the wheel housing.

Installation






Perform the following:

• Check the expanding nuts - 3 - for damage and replace if necessary.

Check the gas-tight expanding nut - 4 - for damage and replace if necessary.

The expanding nuts seal off the passenger compartment from exhaust gas and must always be replaced if they are damaged.

- Install the rear wheel housing liner - 1 - in the wheel housing without kinking.

- Install the bolts - 5 - and hex nut - 6 - and tighten in the specified order. Refer to => [ Front Wheel Housing Liner Bolt Tightening Sequence ] Front Wheel Housing Liner Bolt Tightening Sequence.

- Tightening specification for bolts - 5 -: 2 Nm.

- Tightening specification for hex nut - 6 -: 2.5 Nm.

- Install the wheel.