Outer Seal

Outer Seal

Removing






Perform the following:

- Remove the assembly frame. Refer to => [ Assembly Frame ] Assembly Frame.

- Remove the outer seal - 1 - with the adhesive surface - 3 - from the roof - 2 -.

Installation






Perform the following:

- Remove any remaining adhesive with adhesive remover (VAS 6349).

- The adhesion surface on the roof cutout must be free of dust and grease.

- Clean the adhesive surfaces thoroughly with cleaning solution (D 009 401 04).

- Wipe down the adhesive surfaces on the roof opening with the supplied primer towel.

- Observe the drying times for the supplied primer towel.

- Center the new outer seal - 1 - and the joint - arrows - with respect to the center of the rear roof opening.

- Remove the protective film from the adhesive tape - 3 - and press the seal onto the roof - 2 -.

- Press the outer seal on evenly to prevent any excess length.

- Using the roller (3356) , press the outer seal two times firmly and evenly all the way around.

- Install the assembly frame. Refer to => [ Assembly Frame ] Assembly Frame.