Instrument Housing Cover

Instrument Housing Cover

• It is not necessary to remove the steering wheel to remove the instrument housing cover.

Removing

• Steering wheel set to the end stop in the lowest position.

• Steering wheel set to the end stop in the direction of the vehicle interior.

- Turn off the ignition.

- Remove the instrument trim. Refer to => [ Instrument Trim ] Instrument Trim.

• It is not necessary to unclip the gap cover - 2 -.

- Pry the steering column trim upper part - 1 - out of the mounts using the trim removal wedge (3409).






- Unscrew the 2 screws - 1 - (1.5 Nm) and unclip the instrument housing cover - 2 -.






• During unclipping, the instrument housing cover must be raised slightly above the instrument cluster!

Installation

11 rubber tabs are attached around the periphery of the instrument housing cover. Prior to installation, ensure that the instrument housing cover is equipped with all rubber tabs!

There are 10 metal clips on the instrument housing cover. These serve as a mount for the trim molding on the driver side. Prior to installation, ensure that the instrument housing cover is equipped with all 10 metal clips!

- To install, perform the steps used for removal in reverse order.