Fuel Filter: Service and Repair

Fuel Filter

Special tools, testers and auxiliary items required

• Wrench (T10202)

• Torque Wrench (40-200 Nm) (V.A.G 1332)

• The fuel filter is located in the left fuel tank opening, when viewed in the direction of travel.

Removing

- Read the safety precautions before starting. Refer to => [ Safety Precautions ] Safety Precautions.

- Follow the rules of cleanliness. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the rear seat bench.

- Fold the carpet to the side.






- Loosen the nuts - 1 through 4 - for the flange cover.

- Remove the flange cover.

- Disconnect the connector - arrow - from the fuel filter flange.






- Remove the lock ring from the fuel filter flange using the wrench (T10202).






- Lift the flange and disconnect the connector - 1 - from the fuel level sensor.






• Siphon the fuel out, as necessary. Refer to => [ Fuel Tank, Draining ] Fuel Tank, Draining.

• The ground wire - 2 - can remain connected.

- Disconnect the fuel lines - 1 and 2 - from the fuel filter housing.






• Squeeze the buttons on the line couplings.

- Remove the fuel filter through the opening in the fuel tank.

- Drain the fuel filter housing.

Installing

Installation is carried out in the reverse order while noting the following:

- Replace the flange seal.

- Make sure the fuel level sensor connector, the ground wire and the fuel lines are secure.

- Install the flange in the direction of travel - arrow -.






The tab - 2 - must be between the tabs - 1 and 3 - on the fuel tank.

- Tighten the lock ring to 145 Nm using the wrench (T10202).