Antenna Module on Side Windows, Lower

Antenna Module on Side Windows, Lower

The left and right antenna modules are installed and removed in the same way.

Removal

- Switch off the ignition and all electrical consumers.

- Fold up the center part of the luggage compartment floor.

- Remove the cover from the lock carrier..

- Remove the tie-downs.

- Remove the right section of the luggage compartment floor.

- Remove the right D-pillar trim..

- Remove the retaining clip - arrow -.






- Unclip the side panel trim on the side window and carefully press in the - direction of the arrow - slightly to the side.






- Disconnect the harness connectors from the switches in the side panel trim. If necessary, unclip the interior lamp from the side panel trim.

- Disconnect the harness connectors - arrows - from the antenna module.






• Be especially careful when doing this because the wire and harness connector are extremely sensitive to mechanical stress.

• If the wire connection between the antenna module and side window is damaged, the side window must be replaced. It is not possible to repair the wiring connection.

- Remove the screw - arrow - from the antenna module.






- Slide the antenna module in the - direction of the arrow -.






- Remove the antenna module in the - direction of the arrow -.






If several antenna modules are removed, mark the assignment of the individual modules to their installation location.

Installing

Install in reverse order of removal.