Electronic Steering Column Lock Control Module

Electronic Steering Column Lock Control Module

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

• Vehicle Diagnostic Tester (VAS 5051B)

Removing

- Remove the steering column. Refer to => [ Steering Column ] Steering Column.

- Remove bolt - arrow -.






- Slightly lift the electronic steering column lock control module (J764) - 1 - and remove it from the steering column.

• After removal of the control module, make sure no dirt or foreign objects enter the steering column.

Installing

Install in reverse order of removal. Note the following:

• If only the electronic steering column lock control module was replaced, used the previously used control module bolt.

• If the steering column was replaced, the electronic steering column lock control module is already installed on the new steering column.

- Install the electronic steering column lock control module - 1 - with the pin in the groove - arrow - in the steering column.






- Tighten the bolt.

• If the same steering column and the same electronic steering column lock control module are being installed, then it is not necessary to adapt the electronic steering column lock control module again.

• If the electronic steering column lock control module was replaced, then it must be reprogrammed.

• If the steering column is replaced, the electronic steering column lock control module is already installed on the new steering column and does not need to be modified.

If the electronic steering column lock control module was replaced, the electronic steering column lock control module must be adapted.

Use the (VAS 5051B).

Body

Body

01_OBD-capable systems

05_Access and start authorization => J393

09_Access and start authorization functions

Tightening Specification