Cap without Lock Cylinder

Cap without Lock Cylinder

Special tools, testers and auxiliary items required

• Assembly tool (T10389)






Removing






Perform the following:

- Remove the plug - 2 - from the rear opening.

- Insert the assembly tool (T10389) approximately 55 mm into the door behind the locking hook - 3 - of the mounting bracket.

- Pull the assembly tool (T10389) toward the rear - arrow - until the hook is released.

- Remove the door handle - 2 - from the door in the - direction of arrow a -.






- Remove the cap - 1 - from the mounting bracket - arrow b -.

Installation

Perform the following:

- Remove the door handle - 2 - from the door in the - direction of arrow a -.






- Insert the cap - 1 - into the mounting bracket - arrow b -.






- Insert a screwdriver - 4 - at the locking hook - 3 - of the mounting bracket.

- Install the cap - 1 - in the door.

- Push the screwdriver in just far enough - arrow - to release the hook.

- Secure the plug - 5 -.