Rear Glass Panel

Rear Glass Panel

Removing

• When unscrewing the screws, use a magnetic tool so that the screws cannot fall into the panorama sunroof guide.






Perform the following:

- Remove the seal - 3 - from the assembly frame.

- Remove the left and right screws - 2 - from the glass panel - 1 -.






- Slide the rear glass panel - 1 - slightly under the front glass panel - 3 - - arrow a -.

- Lift the rear glass panel - 1 - only in the rear area off of the roof opening - 2 - - arrows b -.

- Guide the rear glass panel - 1 - up at an angle - arrow c - over the roof - 2 - and pull out from under the front glass panel - 3 -.

Installation

• New screws are to be used when installing the glass panel.

• When installing the screws, use a magnetic tool so that the screws cannot fall into the panorama sunroof guide.






Install in reverse order of removal.

Perform the following:

- Install the rear glass panel - 1 - from above at an angle under the front glass panel - 3 -.

- Install the rear glass panel - 1 - downward in the rear region into the roof opening - 2 - and slide it back.






- Install but do not tighten the bolts - 2 -.

- Adjust the rear glass panel - 1 -.

- After the rear glass panel is adjusted, tighten the screws. Tightening specification: 7 Nm.

- After completing all work, perform an adaptation of the sunroof motor. Refer to => [ Panorama Sunroof Adaptation ] Panorama Sunroof Adaptation.