Sunroof / Moonroof: Testing and Inspection

Panorama Sunroof Adaptation

• Whenever a glass panel, a motor, the tilting mechanism or the sun shade is replaced, it is necessary to perform an adaptation for the appropriate drive.

• Pinch protection is switched off when performing an adaptation.

Adaptation sunroof motor

The ignition is switched on.

The rotary knob must be in the "sunroof closed" position.

- Pull the rotary knob - 1 - down - arrow - and hold in this position during the entire adaptation procedure (approx. 20 sec).






- During the adaptation process, the glass sunroof will first close and then retract by approximately 200 mm.

- After the panel closes again, the adaptation process is complete and the rotary knob can be released.

Motor adaptation process for the sunshade

The ignition is switched on.

- Press the button to close the sun shade - 3 - and hold in this position during the entire adaptation process (approx. 20 sec).






- During the adaptation process, the sunshade will first close and then retract by approximately 200 mm.

- After the sun shade has been closed again all the way, the adaptation process is complete and the control switch can be released.