Seat Adjustment Control Module

Seat Adjustment Control Module

Removing

- Remove seat. Refer to => [ Front Seat ] Front Seat.

- Disconnect the harness connectors - 2 to 5 - on the control module - 1 -.






- Unclip the tabs - arrows - using the trim removal wedge (3409).

- Carefully tilt the control module - 1 - out of the tabs - 2 - in the - direction of arrow B -.






- Slide the control module in the - direction of arrow A -.

- Detach the control module retaining tabs - arrow - from the bracket.

- Remove the control module from the bracket.

Installing

Make sure that the 32-pin connector is connected with the control module beforehand to ensure that the seat adjustment control module does not become damaged.

Install in reverse order of removal. Note the following:

• Make sure the seat adjustment control module audibly engages in the bracket.

• Make sure the electrical connectors are pushed in as far as the stop and that they engage audibly.