Crankshaft, Cylinder Block - Fastener Tightening Specifications

Fastener Tightening Specifications






• 1 Always replace

• 2 Install using liquid locking compound (D 000 600 A2)

• 3 The contact surfaces of the adjuster wheel and bolt head must be dry when installing

• 4 Tightening specification affects the function of the knock sensor

• 5 Tighten in a diagonal sequence and in steps

Accessory Bracket Bolt Tightening Sequence and Specification






- Tighten the bolts in 2 passes in sequence - 1 through 5 - as follows:






Sealing Flange (Transmission Side) Bolt Tightening Sequence and Specification






- Tighten the bolts in 3 passes as follows:

1. Tighten the bolts - 1 - to 5 Nm.
2. Tighten the bolts - 2 - to 23 Nm.
3. Tighten the bolts - 1 - to 10 Nm.