Turn Signals: Service and Repair

Turn Signals

• Removal and installation are described only for the left turn signal. The removal and installation of the right turn signal are derived accordingly from this.






Perform the following:

Removing

- Remove the mirror glass. Refer to => [ Mirror Glass ] Mirror Glass.

- Remove the frame. Refer to => [ Frame ] Frame.

- Remove the mirror housing. Refer to => [ Mirror Housing ] Mirror Housing

- Release the latching mechanism - arrow a - and tilt the trim - 6 - down - arrow b -.

- Remove the bolts - 2 -.

- Disconnect the harness connector - 3 - and remove the side turn signal - 1 -.

Installation

- Connect the harness connector - 3 - and install the side turn signal - 1 -.

- Screw in the bolts - 2 -, tightening specification: 1 Nm.

- Install and latch the trim - 5 - - arrow a -.