Diagnostic Test Mode 6

Diagnostic Test Mode 6

DTM 6 can be used to enter data in the tranmission control system. The adaptive (self-adjusting) throttle signal and shifting-speed adjustment functions can be reset. The shifting speed must be reset when the transmission is replaced.

NOTE: DTM 6 has not yet been integrated into the transmission control system. This will be available in the future. It is however possilbe to follow the method described in this DTM. The operation of the transmission will not be affected.

Diagnostic Test Mode 6 is activated by pressing the DLC button six times in quick succession after DTM 5 has been activated.

Activating Diagnostic Test Mode 6






Activation is in two stages: Reading in DTM 5 and resetting in DTM 6.

- Ignition ON
- Activate DTM 5
- Select the adaptive function that is to be reset.
- Enter the selected code according to the table below. Enter one digit each time the LED comes on.

The LEDs will respond with a flashing code. Use the conversion table below to obtain the status readout.






- Make a note of the code for the response in DTM 5.

- Activate DTM 6 by pressing the DLC button six times within 30 seconds of the response being given.






When the LED lights enter the selected code for resetting according to the table below.






Once the selected code has been entered, the adaptive value has been reset to its normal value.