DTC 2-1-2

Conditions For Code
Driver/passenger airbag igniters resistance too high (indicating a wiring open circuit).

Fault Symptoms
None, except for operation of SRS lamp.

Fault Source
Open circuit in wiring, connectors or airbag module.

Action
1. Turn ignition switch to Off position, then disconnect battery ground cable.
2. Disconnect electrical connector of suspect airbag module, then connect special tool 998 8695 to connector.
3. Clear codes, then display codes.
4. If code does not recur within 15 seconds, replace airbag module. If code recurs, proceed as follows:
a. Connect ohmmeter between one of igniter connector pins and corresponding pin in crash sensor connector. Repeat for other pins in two connectors. If resistance is 0 ohm, wiring is intact. If resistance is infinite, module wiring is short circuited. Measurement must not be carried out directly on module, or deployment may result.
b. Check wiring and connectors between crash sensor and module in question. If code 2-1-2 is displayed, also check contact reel for short circuit. Airbag module must be disconnected before carrying out this measurement.
c. Ensure that code does not recur when new module has been installed.