Cable Routing Mechanical Seat, Side Height Adjust
B6CABLE ROUTING MECHANICAL SEAT, SIDE HEIGHT ADJUSTMENT
Operations:
According to the working method below and illustrations B7-B9.
SEAT WITH MECHANICAL BELT TENSIONER (E) (NOT IN NORTH AMERICAN MARKET):
- Route cable (A) from the belt lock outside the side panel if there is one.
SEAT WITH FIXED BELT LOCK (F):
- Route cable (A) from the belt lock inside the side panel if there is one.
COMMON:
- Route cable (A) from the belt lock over the seat frame if it has a side-mounted height adjustment lever in accordance with the following illustrations.
- Install new protective tape (B) (P/N 6812838-8) under the cable where it passes over the upper and inside of the seat frame.
- Install another protective tape (P/N 6812838-8) over cable at (B) where it passes over the seat frame.
- Fix cable harness with clamps (P/N 948211-8) to the seat frame and the spring bed.
- Fix the cable harness so that the sharp ends of the springs cannot damage the harness and tightly enough that that harness does not hang down below the seat.
The number of clamps and their location is indicated in the illustrations B7-B9.
- Install the seat in the car in accordance with the description in the Service Manual.
CHECK:
- that the seat can run to all its stop positions without damaging the cable and that the cable does not prevent the movement of the seat.
- that all electrical equipment in the seat works.
B7
Cable routing mechanical seat, side height adjustment without heating
B8
Cable routing mechanical seat, side height adjustment with standard rated heating
B9
Cable routing mechanical seat, side height adjustment with high output rated heating