Checking SRS Warning Lamp
Checking SRS warning lamp
Checking SRS warning lamp
- Ignition on.
Is the SRS warning lamp in the combined instrument panel lit?
Yes - No Fault Found
No - Replacing component
-------------------------------------------------
Replacing component
- Ignition off.
Check and replace SRS warning lamp in the combined instrument panel if broken.
Was bulb broken?
Yes - Verification
No - Intermittent fault
-------------------------------------------------
Intermittent fault
The test shows that the fault is intermittent. Fault trace cabling between SRS sensor module and combined instrument panel connector B terminal 3 as per Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Continue - Fault tracing information
-------------------------------------------------
Verification
- Ignition on.
The SRS warning lamp in the combined instrument panel should lit.
OK - FAULT FOUND
Not OK - Fault tracing information
-------------------------------------------------
Fault tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking SRS warning lamp
-------------------------------------------------
Fault tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Checking SRS warning lamp
-------------------------------------------------