Removing the Diode Kit

1
Removing power diode





If a power diode has been installed, it must be removed.

Switch ignition off.

Remove glove compartment.

Note!
Please observe SRS warning labels and SRS information.





Remove passenger side soundproofing panel behind the glove compartment edge.

2
Remove power diode





Remove blower resistor.

Remove power diode.

Seal holes in heater housing by installing pop rivets, P/N979878-6.

Seal the filed holes with silver tape, P/N 277063-4, 60 x 15 mm (23/8" x 5/8").

Install the tape so that it covers both sides of the edge.

Discard the power diode and reinstall other removed components.

3
Finishing

Check that the blower tan functions at all fan settings.