Lifting Power Seat In & Out

Lifting the power seat in and out

Special tools:�951 1522

Removing seats

Preparations

Note! When removing a seat from a car with side airbags, the seat must be grounded. This is due to the danger of static electricity. When the seat has been removed from its screwed joint, but before it is lifted out, secure ground lead 951 1522 or splice a suitable length of cable (stripped at both ends) to the rear mounting or similar (The rear mounting is metal colored). Secure the other end in the car to a suitable metal object that has a greater mass than the seat.

Remove:






- the battery negative terminal
- the end mounting. See Seat belt buckle end mounting

Note! Before removing seats, see SRS connector.

- the panels (B) over the seat rails
- the 4 mounting bolts (C) in the seat rails
- the 5 connectors (under the seat)
-lift the seat straight up (locating pins at the front and rear edges).

Installation

In reverse order.
Tightening torques, seats / floor: 40 Nm ±10