Dashboard / Instrument Panel: Service and Repair

Glove compartment lid
- Service and Repair

Glove compartment lock cylinder
- Service and Repair

Steering wheel with switches
- Service and Repair

Center console
- Service and Repair

Passenger side airbag module
- Service and Repair

Dashboard

Windshield wipers
- Nut M8, 13mm.



Gutter
- Torx 20 screws with washers.

Wiper motor mounting and dashboard screws
- 2 nuts, 10mm nuts for wiper motor mounting.
- 4 M6, 10mm screws for dashboard.



Left-hand side soundproofing panel
- 1 Torx 20 screw.



Right-hand side soundproofing panel
- To access the screws remove the glove compartment
- 2 Torx 20 screws behind the glove compartment.



Dashboard screws in passenger compartment
- 4 Torx 20 screws.
- Lift dashboard out of the car.



Valve housing
- 2 Torx 20 screws for the valve housing. The valve housing is located on the back of the dashboard. remove the damper control from the valve housing and pull it out.



Valve housing and air ducts
- (the illustration shows the back of the dashboard.) 3 Torx 20 screws.



Air vent housing and air ducts
- (The illustration shows the reverse of the dashboard) 2 Torx 20 screws.



Combined instrument panel trim
- (The illustration shows the reverse of the dashboard) Cable duct: 2 Torx 20 screws. Combined instrument panel frame: 8 Torx 20 screws.



Frame center
- (The illustration shows the reverse of the dashboard) 13 Torx 20 screws.



Cable harness routing
- (The illustration shows the reverse of the dashboard) 2 Torx 20 screws holding the cable duct. The cable harness is secured with clips. The securing points are marked with arrows.



Cable harness routing
- (The illustration shows the reverse of the dashboard) The cable harness is secured with clips. The securing points are marked with arrows.

Zeroing contact reel
- Service and Repair