Body - Replacing Weatherstrip for Trunk Lid
SECTION8
GROUP
84
NO.
821
DATE
May 1997
Replacing weatherstrip for trunk lid, S70
Background: Early S70 models have a spacer on each side under the trunk lid weatherstrip, so the molding can be lifted and seals the lid more effectively. The new type of weatherstrip is supplied as a replacement part with inbuilt spacers inside the sealant part of the molding. When replacing the molding, older spacer models should be removed from the bodywork at the trunk lid-opening two front corners, according to the procedure below (so the lid will not be deformed when closed).
Chassis no.:
874 1 - 435514
874 2 - 440539
Materials:
Weatherstrip 9152938-8
Removing spacer from bodywork
When replacing to weatherstrip with spacers inside sealant part of molding.
Remove:
- weatherstrip from the bodywork.
- the spacers from the bodywork at the trunk lid-opening front corner as illustrated.
Install:
- new weatherstrip with spacers inside sealant part of molding.
Note! The trunk lid can be deformed by pressing it up too high when closing, if "spacers on bodywork" are combined with the new molding (which has spacers inside the sealant part of the molding).
WARRANTY STATEMENT: Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type: 01
