Front Seat - Height Adjuster Knob
Section8
Group
85
No.
0007
Year
99
Month
10
S70/V70/V70XC/C70
1998-1999
Reference: This Service Bulletin replaces Service Bulletin 85-0007 dated August 1999, which should be discarded.
Title
Front seat, height adjuster knob
Background
This Service Bulletin describes how to install the new style height adjuster knob handles for the front seats.
Model Factory Chassis No.
S70 2 -609263
V70 2 -609946
C70 Coupe J -013183
C70 Convertible J -013183
V70 XC 2 -609946
Material
Description Quantity Part No.
Control knob front left 1 9475548
Control knob rear left 1 9475550
Control knob front right 1 9475549
Control knob rear right 1 9475551
Screw M4*6 4 980893
Front seat, height adjuster knob
1
Removing control knob (front and rear)
Carefully bend out the lock tab on the inside of the knob.
Pull the knob upwards. (See illustration)
2
Marking and drilling holes
Warning!
When drilling holes, use eye protection.
Mark up where the hole is to be drilled.
A =23.4 + 0.3 mm (59/64" + 0.010") from the upper edge.
B =9.0 + 0.2 mm (29/64" + 0.008") from the side edge.
Position counterhold behind the height adjustment lever so that lever and the plastic cover are not damaged during centerpunching and drilling. A 5 mm (1/4") flat steel bar or equivalent is suggested.
Carefully center punch before drilling.
Drill holes, 3.5 mm (9/64").
3
Marking and drilling holes
Warning!
When drilling holes, use eye protection.
Mark up where the hole is to be drilled.
A = 21.7 + 0.3 mm (55/64 + 0.010") from the upper edge.
B = 9.1 + 0.2 mm (29/64" + 0.008") from the side edge.
Position counterhold between the height adjustment lever and its cover. A 5 mm (1/4") flat steel bar or equivalent is suggested.
Position the counterhold in such way that the cover is not damaged during or after drilling.
Carefully center punch before drilling.
Drill holes, 3.5 mm (9/64").
4
Installing control knob (front and rear)
Install new adjuster knob.
Install 2 new screws (part number 980893).
Tighten to 2.5 Nm (1.8 ft.lb).
WARRANTY STATEMENT: Claims may be submitted under the New Car Warranty when there is a documented customer complaint, using claim type 01.
Operation No. Labor description Time allowance
85224-2 Replacing seat control knob 0.1hr