Steering Wheel Adjuster

Tool Required
^ 999 8081 Torque Wrench

NOTE: The steering column must be removed to replace steering wheel adjuster components.





1. Remove nut and dismantle adjuster components.





2. Replace damaged and worn components.





3. Commence reassembly by installing springs and bracket, together with inner washers.





4. Install lever sleeve, bolt, friction washers, bearing washers and bearing. Tighten nut carefully.





5. Adjust friction using nut on other side of steering column. Use torque wrench and 10 mm hexagonal socket. Torque: 2.6-2.8 Nm (1.9-2.1 ft. lbs.).





6. Mount lever on bracket. Lever should be in position shown when adjuster is released. If position is different, turn lever counterclockwise to correct position.

NOTE: Adjuster must be mounted on steering column when column is installed in car.