Internal Fault
PB1 Status Check:
- Ignition on.
- Read off diagnostic trouble code (DTC) counter and make a note of the value. Is counter value greater than 0?
Yes: PB5
No: PB2
PB2 Data Read-Out:
Read off all data from the combined instrument panel control module and note values. Then continue with PB3.
NOTE: For information see "Reading Off and Programming Combined Instrument Panel". Reading Off and Programming Combined Instrument Panel
PB3 Replacing Component:
Try a new connection plate according to DDJ. Replacing connection plate. Service and Repair Then continue with PB4.
PB4 Programming Combined Instrument Panel:
Program the control module with the values previously read off the combined instrument panel control module.
NOTE: For information see "Reading Off and Programming Combined Instrument Panel".
PB5 Faulty Signal, Intermittent Fault:
Combined instrument panel control module OK.