Not Programmed

QB1 Status Check:





- Ignition off.
- Read off diagnostic trouble code (DTC) counter and make a note of the value. Is counter value greater than 0?

No: QB2
Yes: QB3

QB2 Programming Combined Instrument Panel:





- Ignition on
- Program the control module with the values previously read off the combined instrument panel control module. Then continue with QB3.

NOTE: For information see "Reading Off and Programming Combined Instrument Panel". Reading Off and Programming Combined Instrument Panel

QB3 Intermittent Fault, Signal Faulty:
Combined instrument panel is OK. Erase diagnostic trouble code (DTC).