Operation CHARM: Car repair manuals for everyone.

Signal Too Low. Intermittent Fault

SIGNAL TOO LOW. INTERMITTENT FAULT





Checking Cables and Terminals

WARNING! Before fault-tracing disconnect Engine Cooling Fan (FC) relay connector A so that the engine cooling fan (FC) will not run. Diagnostic Trouble Code (DTC) EFI-514 engine cooling fan (FC) low-speed, signal may be stored. After fault-tracing the connector must be reconnected.

- Check cable between Engine Coolant Temperature (ECT) Sensor terminal 1 and Engine Control Module (ECM) #A31 for an intermittent short-circuit to ground.

Then continue with test step below.

Fault-Tracing Information

- For intermittent faults fault-tracing is not followed by a verification because the fault is not present at this moment.
- Do you want to repeat fault-tracing?

Yes:
- Retun to Checking Cables and Terminals section above.

No:
Operation done.