Signal Too High. Intermittent Fault
SIGNAL TOO HIGH. INTERMITTENT FAULTChecking Cables and Terminals
- Check outside temperature sensor and control module connectors for loose connections, contact resistance and oxidation.
- Check cable between outside temperature sensor terminal 1 and engine control module (ECM) #A35 for an intermittent open-circuit or intermittent short-circuit to supply voltage.
- Check cable between outside temperature sensor terminal 2 and engine control module (ECM) #A18 for an intermittent open-circuit.
Then continue with test step below.
Fault-Tracing Information
- For intermittent faults fault-tracing is not followed by a verification because the fault is not present at this moment.
- Do you want to repeat fault-tracing?
Yes:
- Return to Checking Cables and Terminals section above.
No:
- Operation done