Trouble Code Conditions

6-1-6 EVAP CANISTER SHUT-OFF VALVE, SIGNAL





Trouble Code Conditions
- Diagnostic trouble code (DTC) EFI-616 (EVAP canister shut-off valve, signal) is stored if the engine control module (ECM) registers a fault in the EVAP canister shut-off valve coil or wiring.

Substitute value(s)
- Leakage diagnostic is turned off.

Possible source(s)
Signal too high:
- Short-circuit to supply voltage in signal cable.
- Defective EVAP canister shut-off valve.

Signal too low:
- Short-circuit to ground in signal cable.

Signal missing:
- Open-circuit in signal or power cable.
- Defective EVAP canister shut-off valve.

Fault symptom(s)
- None.





Other DTCs and Status Messages
Status message
- Select one of the following options to continue:

Alternative 1:
- Refer to: Signal Too High: Permanent Fault.

Alternative 2:
- Refer to: Signal Too Low. Permanent Fault.

Alternative 3:
- Refer to: Signal Missing. Permanent Fault.

Alternative 4:
- Refer to: Signal Too High. Intermittent Fault.

Alternative 5:
- Refer to: Signal Too Low. Intermittent Fault.

Alternative 6:
- Refer to: Signal Missing. Intermittent Fault.