Door lock - Installation of protective cover

Bulletin:
8830032

Group:
83

Date:
03/01/2000

Door lock, installation of protective cover

Models:
S70/V70/V70 XC
1998-2000

Reference: This Service Bulletin replaces the previous Service Bulletin 8-83-0032 from February 2000, which should be discarded.

Purpose: Labor description is changed.

Background:

A protective cover for the door locks has been introduced to help prevent moisture from entering the lock unit causing intermittent operation due to freezing. The protective covers are separate replacement parts and are supplied as a kit containing four covers.

Replacement of the door lock unit for this condition is not necessary.




Material

DOOR LOCK, INSTALLATION OF PROTECTIVE COVER

Installation of the protective cover for the door lock

REMOVAL

Removing door panels

Remove the door panels according to, Front and rear doors.

Or the method in Service Manual: Section 8 (82-86,88) Interior trim, exterior 570N70 1997-.

Removing the panel for the door lock





Remove the panel (1).

Remove the cable from the door panel.

Note! Only the front door is illustrated.

Removing the lock button





Detach and remove the lock button (1) from the lever.

Note! Only the front door is illustrated.

Disconnecting the guide rail (rear door)





Remove the lower screw (1) for the guide rail.

Do not move the guide rail more than 30 mm sideways from the lower mounting point when removing the lock.

Disconnecting the lock unit (front and rear doors)





Remove screws (B), Torx 30.

Note! Only the front door is illustrated.

INSTALLATION

Positioning the protective cover





The protective covers have stamped markings that indicate the left and right hand sides.

Slide the lock out of the door.

Insert the cover at an angle over the lock (1). Position the channel (2) (on the outside of the cover) over the corresponding projection on the lock. The cover will then be positioned correctly on the lock.

Installing the protective cover





Install the protective cover (1) over the lock.

Installing the lock unit





Slide the lock unit back into place, and fasten it with new screws. Tighten to 7.4 ft-lb (10 Nm).

Installing the removed components, function test

Reinstall all removed components in reverse order

Check all door lock functions, including remote locking and unlocking.

Check all other electrical functions related to removing and installing the door panel.





WARRANTY STATEMENT: Claims may be submitted under the New Car Warranty when there is a documented customer complaint, using claim type 01.