Campaign - Starter/Ignition Switch Replacement

Section
3

Group
33

No.
0002

Year
98

Month
05

Reference: TP6001201, Section 6, 7 (60-64, 70-77) Front end, steering 850 1992-

Service campaign no: 83 D, Starter/ignition switch, replacement

Part required: Starter switch P/N 9447804 Quantity 1





Starter switch, replacement

Starter/ignition switch, replacement

Remove 1

Disconnect the negative battery cable.

Note!
The steering wheel does not have to be removed to replace the starter switch.





Release the lock for the tilt/telescope adjustment and pull the steering wheel toward the rear of the vehicle and lock the wheel in this position.

Remove the steering column covers.

Removing electrical components 2

Carefully separate the connector from the starter switch.

Remove the two screws that holds the starter switch to the ignition lock.

Carefully remove the starter switch from the ignition lock.

Installing ignition switch 3

Before installing the starter switch; make sure that the center key hole in the starter switch is properly aligned with its corresponding dowl key in the ignition lock. Reconnect the wiring connector to the ignition switch.





Reinstalling panel and steering wheel covers. 4

Caution!
Route the wire harness for the starter switch so that no schafing and/or pinching can occur when reinstalling the steering column covers.

Reinstall column covers.
Reconnect battery.
Set radio code.