Trouble Code Conditions
4-4-6 PULSED SECONDARY AIR INJECTION SYSTEM VALVE, LEAKAGETrouble Code Conditions
- The pulsed secondary air injection system (PAIR) pump valve is checked by disabling the long-term fuel trim and stopping canister purge (CP) valve control. The pulsed secondary air injection system pump is started and the pulsed secondary air injection system pump valve is kept closed, if the short-term fuel trim integrator rises above a set value within 6 seconds diagnostic trouble code (DTC) EFI-446 is stored.
Substitute value(s)
- Fuel trim disabled.
Possible source(s)
- If Code EFI-442 Pulsed Secondary Air Injection System Flow Fault and Code EFI-446 Pulsed Secondary Air Injection System Leakage Fault are stored at the same time:
^ Leaking pulsed secondary air injection system valve.
^ Defective pulsed secondary air injection system solenoid valve.
^ Air leakage in the exhaust system.
- If Code EFI-448 Pulsed Secondary Air Injection System Pump Flow Fault is stored together with the above diagnostic trouble codes, the following also applies:
^ Pulsed secondary air injection system pump runs continuously.
^ Air leakage in the exhaust system.
^ Damage/hole in the hose between pulsed secondary air injection system pump and pulsed secondary air injection system valve.
Fault symptom(s)
- A muffled sucking sound can be heard from the engine compartment when the engine is idling.
Other DTCs and Status Messages
Status message
- Select one of the following options to continue:
Alternative 1:
- Refer to: Leakage. Permanent Fault.
Alternative 2:
- Refer to: Leakage. Intermittent Fault.