Procedures

Special Tools
999 5702

Removing ignition coil(s)





- Remove both engine covers.
- Disconnect the connectors.
- Disconnect the HT lead.
- Remove the mounting screws.
- Pull off the ignition coils.

Installing ignition coil(s)





- Check the rubber and the spring inside. Replace if necessary.
- Position the ignition coils. Press the ignition coils into place.
- Tighten the screw. Tightening torque 10 Nm.
- Connect the high tension cables.
- Reconnect the connector.

Note! The gray connector is for the left coil (cylinders 2 and 3), the blue connector is for the right coil (cylinders 1 and 4).

- Check the function.
- Reinstall both engine covers