Automatic Transmission

Signal too low. Permanent fault

Checking signal cable
Check signal cable between:
- combined instrument panel #A2 and ABS control module #10
- ABS control module #10 and transmission control module (TCM) #B2
- transmission control module (TCM) #B1 and engine control module (ECM) #B1
- engine control module (ECM) #A55 and throttle unit #4
for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting breakout box, Combined instrument panel Connecting the Breakout Box.
- For information about signals, see Connector A, #A1 - #A30 , Connector B, #B1 - #B16 and Connector D, #D1 - #D5.





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall connectors, components etc.
- Ignition on.
Read off diagnostic trouble code (DTC) DIM-DF14 status.





Has the status switched to intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking signal cable

-------------------------------------------------