Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking cables
Check cable between injector terminal 2 and control module:
- #A16 (#A16) (ECM 2310)
- #A34 (#A34) (ECM 2320)
- #A15 (#A15) (ECM 2330)
- #A33 (#A33) (ECM 2340)
- #A14 (#A14) (ECM 2350)
for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- To access/replace the injector, see Service and Repair.
- For information about signals, see Signal specification Signal Specifications.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking cables

FAULT FOUND - DONE

-------------------------------------------------