SIPS Airbag

SIPS airbag

Preparations





Remove:
- battery negative terminal.
- the backrest upholstery according to Backrest upholstery Backrest Upholstery.

Removing the front seat SIPS airbag
Fold out and remove the protective pad on the side of the seat that contains the SIPS airbag.





Remove:
- the two screws that hold the SIPS airbag to the inside of the backrest frame.
- tie straps.
- steel clip.




Disconnect the connector clip.
Cut the tie strap.
Expose the wiring.
Replace the SIPS airbag.

Installation

Install:
In reverse order.
Tighten the SIPS airbag screws to: 6 Nm.
To install decals see Airbag steering wheel module, steering wheel and contact reel Airbag Steering Wheel Module, Steering Wheel and Contact Reel Replacement.