Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-904C

Condition




This diagnostic trouble code is only stored when the electronic throttle module (ETM) has reported a fault for both throttle position sensors during the same operating cycle. This means that this diagnostic trouble code will always be found together with ECM-9150 and/or ECM-9160.
For upgraded software, released during year 2006 or later, this diagnostic trouble code is used as an information diagnostic trouble code. It will be stored in cases where then replacement value, Fuel shut-off that follows the throttle, is or has been activated as well as the fuel shut-off has been active so much that there is a risk of increased emissions. The diagnostic trouble code is always stored as the result of another trouble code. Troubleshooting is not required.
Identifying upgraded software ECM/ETM Testing and Inspection
For more information about the electronic throttle system and related components such as the electronic throttle module, accelerator pedal position sensor, brake light switch, clutch pedal position sensor, and brake pedal position sensor: Design Design

Substitute value
- none
For upgraded software, released during year 2006 or later, no replacement values are activated for this diagnostic trouble code. As mentioned in the conditions this diagnostic trouble code, when stored, will be stored together with another diagnostic trouble code, which has activated the replacement value, Fuel shut-off, which follows the throttle.
Identifying upgraded software ECM/ETM Testing and Inspection

Possible source

Faulty signal:
- other diagnostic trouble code (DTC) is stored.
This diagnostic trouble code is generated in combination with other trouble codes. Information on the possible root cause is described.

Fault symptom[s]
- Driving/Poor performance/lacks power
- Idling/Uneven idle