WHIPS

WHIPS

Preparations

Remove:
- the seat from the car. See Lifting mechanical seats in and out Lifting Mechanical Seats In and Out
- the lumbar support knob. See Lumber support adjustment knob, replacing Lumbar Support Adjustment Knob, Replacing
- the backrest adjustment knob. See Backrest adjustment knob Backrest Adjustment Knob

Replacing WHIPS




If indicator B is not intact:
Screw the backrest adjustment as far forwards as possible.
Release folding mechanism A. Fold the backrest forward.
Disconnect spring C.





Remove:
- the indicator pin or its remains
- one nut on each side.




- one shaft / screw on each side
- sliding washer.
Use a screwdriver to lift apart the mounting at C in order to angle out segment B.




Remove the segment: Twist it and angle it out.

Note! The segment can only be removed when it is in one particular position.

Replace the segment.

Install:
In reverse order.

Note! The nut must be tightened. Tighten to 17 Nm ± 1 Nm.

Note! The sliding washer must be positioned correctly.

Check that the indicator pin is intact and is correctly positioned after installation.