Fault-Tracing and Programming Using the Volvo Scan Tool (ST)

Fault-tracing and programming using the Volvo Scan Tool (ST)

Preparations

Note! The entry position cannot be programmed using Volvo Scan Tool (ST) on control modules with P/N 8651558. The service is not available on the Volvo Scan Tool (ST) for these control modules. Calibrate manually instead. See Manually programming entry position Manually Programming Entry Position

Location Of Components:

- Adjust the front-rear position of the seat to the most forward position using the control button or the Volvo Scan Tool (ST)
- Move the seat backward approximately 5 mm.

Programming using the Volvo Scan Tool (ST)




- Disconnect the Volvo Scan Tool (ST) from the VIDA-station. Connect the Volvo Scan Tool (ST) to the data link connector (DLC) as a stand alone tool. See Connecting the Volvo System Tester Connecting the Volvo System Tester
- Start the Volvo Scan Tool (ST). Select language, model, bodywork and seat
- Select "Entry position".
- Press "Enter".

Completion
The preset entry position is now programmed into the control module.
Switch off the Volvo Scan Tool (ST) and disconnect it from the car.