Rear

Anti-Roll Bar Rear, Replacing

Special Tools: 951 2050

Raise the car







Remove the left-hand rubber mounting for the muffler
- Hang up the muffler using a tie strap so that the muffler is as high as possible.







Remove the outer nut (1) on the transverse arm mounting. Remove the screw

Mark up the position of the right-hand transverse arm mounting in relation to the hole (2) in the left-hand trailing arm
- Make a punch mark in the mounting at the edge of the hole.
- Remove the other screw from the mounting.

NOTE: It is very important that markings are correctly made. If not the rear wheel toe-in will be incorrect.







Remove:
- the mounting screws for the anti-roll bar
- the anti-roll bar.

Installation

NOTE: Ensure that there is no exhaust leakage.

Install the new anti-roll bar
- Install the screws using new nuts 2, 3. Use a new screw and nut
- Do not tighten the screws yet.







Install the transverse arm mounting on the trailing arm. Use new screws and nuts
- Install the inner screw (1) and the nut. Adjust the mounting using the markings (2) made earlier.
- Tighten the nut so that the position is fixed. Install the screw (3) and the nut.
- Tighten the nuts. Tighten to 50 Nm. Angle tighten to 120 degrees.

Use bevel protractor 951 2050.







Tighten the mounting screws for the anti-roll bar
1. Tighten to 50 Nm
2. Tighten to 50 Nm. Angle-tighten to 90 degrees
3. Tighten to 65 Nm. Angle-tighten to 90 degrees.

Use bevel protractor 951 2050.







Cut off the tie strap holding the muffler

Reinstall the rubber mounting