Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking the signal cable




- Ignition off
- Disconnect the 20-pin connector (group A) from the central electronic module (CEM)
- Disconnect the 1-pin connector from the generator (GEN) (1B).
Check the signal cable between the central electronic module (CEM) terminal #5A and generator (GEN) terminal #1B (the red / white cable with flat pin). Check for a short-circuit to ground.
Remedy as necessary.

Other information:
- To access the central electronic module (CEM), see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- Checking wiring and terminals Checking Wiring And Terminals.





Is the signal cable OK?

Yes - Replacing the component

No - Verification

-------------------------------------------------

Replacing the component
Replace the governor on gasoline engines. See Governor, replacement Service and Repair.
Replace the governor on diesel engines. See Governor, replacing Service and Repair.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect connectors, install components, etc.
- Start the engine.
Check that diagnostic trouble code status changes from permanent to intermittent.





Is the diagnostic trouble code status intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the signal cable

-------------------------------------------------