Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the component and wiring








- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the seat belt buckle
- Disconnect the connectors from the central electronic module (CEM).

Caution! Avoid touching the terminal pins in the control module. There is a risk of static discharge which could damage the control module.

Check the connectors for the seat belt buckles and the central electronic module (CEM). Check for damage to pins and terminals.
Also check the other connector which connects the wiring between the seat belt buckle and the control module.
Remedy as necessary.
Check the wiring between the central electronic module (CEM) and the seat belt buckle connector. Check for a short-circuit and/or an open-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Description, Central Electronic Module (CEM)
- For further information about cable routing and terminals, see the wiring diagram
- Buckle seat belt front, replacing Buckle Seat Belt Front, Replacing
- Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- Checking wiring and terminals Checking Wiring And Terminals

Was a fault detected?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component




Replace the seat belt buckle if no faults are found

Other information
- Buckle seat belt front, replacing Buckle Seat Belt Front, Replacing



Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Check that diagnostic trouble code status changes from permanent to intermittent.





Is the diagnostic trouble code status intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component and wiring

-------------------------------------------------