Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking the wiring and component
Check that the rear fog lamp relay (position 2/49) is correctly installed.
Check the relay terminal (2/49). Check for contact resistance and oxidation. Check for loose connections.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access the rear electronic module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When the relay is installed and activated, the voltage at the relay guide (terminal #2) must be 0 V
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking the wiring and component

-------------------------------------------------