Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking the component




- Ignition off.
Disconnect right seat heater 9/13.
Check the control module for the right-hand seat heater and the connector. Check for contact resistance and oxidation.

Other information:
- Checking wiring and terminals Checking Wiring And Terminals.









Was a fault detected?

Yes - Verification

No - Checking the cable

-------------------------------------------------

Checking the cable




- Ignition off
- Disconnect the connector from the central electronic module (CEM)
- Disconnect connector (9/13) from the front right seat heater.
Check the signal cable between central electronic module (CEM) terminal #4C and front right seat heater (9/13) connector terminal #2. Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.

Other information:
- For information about the central electronic module (CEM) connector, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- For information about signals, see Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring And Terminals













Is the cable OK?

Yes - Replacing the component

No - Verification

-------------------------------------------------

Replacing the component
Replace the right seat heater control module. See Power seat module (PSM), replacing Service and Repair.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Check that diagnostic trouble code status changes from permanent to intermittent.





Is the diagnostic trouble code status intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the cable

-------------------------------------------------