Operation CHARM: Car repair manuals for everyone.

Signal Too Low - Intermittent Fault






Signal too low. Intermittent fault

Checking component and wiring
Check air conditioning (A/C) pressure sensor connector for intermittent contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Check cable between engine control module (ECM) #A68 (#B8) and air conditioning (A/C) sensor #2 for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Check signal cable between engine control module (ECM) #A68 (#B8) and air conditioning (A/C) pressure sensor #2 for an intermittent open circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Check power supply cable between engine control module (ECM) #A39 (#A39) and air conditioning (A/C) pressure sensor #3 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Remedy as necessary

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box.
- Air conditioning (A/C) pressure sensor #2 is the signal cable, #3 is the power supply (5V) and #1 is the signal ground.
- For information about signals, see Signal specification Signal Description / Specification.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking component and wiring

FAULT FOUND - DONE

-------------------------------------------------