Internal Fault - Permanent Fault

Internal fault. Permanent fault

Programming or replacing the engine control module (ECM)




- Ignition off.
The engine control module (ECM) has registered an internal fault. Replace the engine control module (ECM). See Engine control module (ECM), replacing Service and Repair.

Note! After replacing the engine control module (ECM), the throttle unit must be adapted using the vehicle communication input: "Throttle unit adaptation".

Remedy as necessary.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Programming or replacing the engine control module (ECM)

FAULT FOUND - DONE

-------------------------------------------------