Sunglasses Holder

Sunglasses holder


















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Sunglasses holder

Note! The kit illustration shows that the kit includes two screws. This only applies to kits for the S40/V50. The existing screws are reused when installing in the V70/S60, therefore screws are not supplied in these kits.

Preparations

Applies to the S40 (04-) / V50




- Hold the grab handle down where the sunglasses holder will be positioned. The sun glasses holder can be used in all the four locations for the grab handle
- Carefully pry up the two covers on the mounting sections of the handle. Use a flat screwdriver
- Remove the two screws under the covers. Place the screws to one side. New screws are supplied in the kit
- Carefully pull the grab handle off the body and headlining (some force is required).

Applies to the V70 / S60




- Carefully pry up the upper edge of the cover, where the sunglasses holder is to be positioned. Use a plastic weatherstrip tool.

Note! The sunglasses holder can only be installed in the two front seat positions for the grab handle in the V70, but in all four positions in the S60

- Remove the two screws under the cover. Place the screws to one side. The screws will be reused later
- Remove the rubber strip in the upper edge of the door opening
- Carefully bend down the outer edge of the headlining to access the catches at the lower edge of the internal handle
- Press in the catches and twist off the handle into the car.

Note! Do not damage the inflatable curtain.

Installing the sunglasses holder




- Open the sunglasses holder. Hold the sprung cover down
- Position the sunglasses holder where the grab handle was previously located. Tighten the sunglasses holder to the body and headlining. New screws from the kit are used for S40/V50 models. The previously removed screws are used for V70/S60 models
- Tighten the screws. Tighten to 8 ± 2 Nm (6 ± 1.5 lbf. ft.)
- Remove the backing from both ends of the lining in the sunglasses case
- Press the tape at the ends of the lining against the bottom of the sunglasses case.

Using the sunglasses holder




- Open the sunglasses holder and hold the cover down
- Place the glasses in the cover of the case and release. The cover will then spring back against the upper section of the sunglasses holder.