Connector Holder

Connector holder






















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Connector holder




- Mark the hole for the connector bracket for drilling as illustrated.
- Pre-drill with a smaller drill bit. Enlarge the hole with a -6.5 mm (1/4")" drill bit.
- Remove any swarf. Rust-proof the edges of the holes.




- Take out the screw, washer, nut and bracket from the kit.
- Place the bracket over the drilled hole with the text (1) facing backwards. Mark out to cut off the corner of the bumper cover as illustrated.
- Cut off the corner.
- Fit the bracket (with the text (1) facing backwards), with the screw, washer and nut. Do not tighten the bracket yet.




- Place the connector on the bracket as illustrated.
- Adjust the position of the bracket with the connector and tighten the screw/nut correctly.