Engine Mount, Right, Replacing

Engine mount, right, replacing

Special tools:
951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor
999 5972 FIXTURE 999 5972 Fixture

Removal

Removal (the illustrations may be slightly different for different models)




Raise the car.

Remove
- the right front wheel
- both the plastic nuts and the reinforcement panel holding the cover in the right fender liner. Bend the fender liner out of the way.





Remove
- the four screws for the right engine pad
- the splash guard under the engine.




- Position a mobile jack with universal plate 999 5972 FIXTURE 999 5972 Fixture under the oil pan on the right side of the engine
- Check that the plate does not catch in the sub-frame
- Carefully lift the engine slightly so that the engine pad can be removed.

Installation





Install
- the new engine pad
- use new screws for the mounting in the sub-frame and engine. Do not tighten yet.
- Carefully lower the engine and remove the mobile jack
- Tighten the screws against the engine. Tighten to 35 Nm. Angle-tighten 90°. Use bevel protractor 951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor
- Tighten the screws to the sub-frame. Tighten to 65 Nm and angle-tighten 60°. Use bevel protractor 951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor.
- the splash guard under the engine. Tighten to 25 Nm
- both the plastic nuts and the reinforcement panel holding the cover in the right fender liner
- the right front wheel. See Installing wheels Service and Repair