Engine Body, Exposing
Engine body, exposing
Special tools:
998 9721 SCREW SET 998 9721 Screw Set
999 2520 FLOOR STAND 999 2520 Floor Stand
999 5112 GEAR SECTOR 999 5112 Gear Sector
999 5297 ENGINE FIXTURE 999 5297 Engine Fixture
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.
Removing the gearbox
Hint: Remove the lower screws (these are difficult to access) between the gearbox and engine before removing the engine and gearbox unit. The engine and gearbox unit must be placed on a suitable surface.
Relieve the transmission. Loose the remaining screws and remove the transmission carefully.
Remove the clutch.
Removing the flywheel and carrier plate
Install gear sector 999 5112 GEAR SECTOR 999 5112 Gear Sector.
Remove all screws except for the uppermost screw which secures the flywheel to the crankshaft. Slacken off the uppermost screw. Leave it in place, screwed in a few turns.
Carefully work the flywheel and carrier plate loose. If necessary, use 2 groove-cut chisels. Apply these between the cylinder block and the flywheel and carrier plate.
Hold the flywheel and carrier plate and remove the final screw.
Install the engine in a stand
Use mounting stand 999 2520 FLOOR STAND 999 2520 Floor Stand , fixture 999 5297 ENGINE FIXTURE 999 5297 Engine Fixture and screw set 998 9721 SCREW SET 998 9721 Screw Set.
Exposing the engine