Tightening Torque

Tightening the intermediate section







- Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft.
- Lift these and the front of the crankshaft.
- Carefully position the crankshaft in the block.
- The crankshaft must not be turned before the intermediate section has been torque tightened. Position the intermediate section.
- Lubricate and install all the screws.

NOTE: Use new M10 screws.

- Install the intermediate section and the screws on the exhaust side at bearing recesses 2 and 5.

CAUTION: The M8-screws on the exhaust side are two different lengths.

- Pull down the intermediate section.

Tighten the screws in the following order:
1. All M10 screws 20 Nm
2. All M10 screws 45 Nm
3. All M8 screws 24 Nm
4. All M7 screws 17 Nm
5. Angle-tighten all M10 screws 90 degrees

Tighten the screws in sequence from the center and outwards.