DTC ECM-9530

Diagnostic Trouble Code (DTC) Information





Condition
Diagnostic trouble code (DTC) ECM-9530 is stored if the engine control module (ECM) registers a fault in the PWM signal from the accelerator pedal (AP) position sensor when the ignition is switched on

Substitute value
- The accelerator pedal (AP) is not working at all at the same time as the brake pedal is pressed.

Possible source

Signal too high:
- Short-circuit to supply voltage in the signal cable
- Defective accelerator pedal (AP) position sensor.

Signal too low:
- Contact resistance or oxidation in the terminals between the engine control module (ECM) and the accelerator pedal (AP) position sensor
- Open-circuit or short-circuit to ground in the signal cable
- Open-circuit in the power supply (12 V) for the accelerator pedal (AP) position sensor
- Defective accelerator pedal (AP) position sensor.

Fault symptom[s]
- Poor accelerator pedal (AP) response.